Warning! This learning object uses Adobe Flash and your browser does not support Flash. To view this content you will either need to install and/or enable flash in your web browser or upgrade your web browser.
Click Here for instructions to enable Flash.
In this document you'll review thread cutting using a drill press.
Shear - Hydraulic - Adira - Setting Back Gauge
By Dave Hoffman
Step-by-step of setting the back gauge with an Adira Hydraulic Shear.
Logic State Indicators
By Terry Bartelt
Instructions on how to interpret state indicator symbols for input and output terminals of digital devices is presented.
Lathe Project: Crank Handle Body
By Kelly Curran
This project gives a drawing with steps to complete the activity.
Saw Part Identification
Learners examine a photo of a Marvel Vertical Band Saw and then identify the parts in a drag and drop exercise.
Basic Types of Lines Used in Engineering Drawings
By Kelly Curran, Glenn Sokolowski
In this highly interactive object, learners associate basic line types and terms with engineering drawing geometry. A quiz completes the activity.
By Glenn Sokolowski
In this interactive object, learners examine sectional views used in engineering drawings. The sections shown are full, half, offset, aligned, revolved, and broken-out. Learners match drawings of sectional views with the names of the views.
Calculating Cutting Speeds for Twist Drills
Students view the formula for determining twist drill speeds in metal. Exercises complete the activity.
In this document you'll review an overview of cutting fluid types and uses.
Cutting Fluids - Coolant Inspection Project
This project sheet outlines the steps for coolant inspection and charging.
Cutting Speeds and RPM Calculations for Drill Press Operations
You'll practice calculating and selecting the proper cutting speeds for various drill press operations.
Creative Commons Attribution-NonCommercial 4.0 International License.
Learn more about the license »
Give your new group a name.