Warning! This learning object uses Adobe Flash and your browser does not support Flash. To view this content you will either need to install and/or enable flash in your web browser or upgrade your web browser.
Click Here for instructions to enable Flash.
In this animated activity, learners examine how cavitation occurs in a hydraulic pump. A video clip is included. Learners then test their knowledge in a brief quiz.
The Three-Phase AC Generator
By Terry Fleischman
In this 3D animated object, learners examine the way in which a three-phase generator produces three sine waves with three armature coils. A quiz completes the activity.
Interpreting Engineering Drawings: Title and Revision Blocks
By Glenn Sokolowski
Learners examine the information on a title block and answer questions about that information in an interactive quiz.
PLC Counter Instructions
By Terry Bartelt
In this animated object, learners examine the operation of up-counters and down-counters for a programmable controller. A brief quiz completes the activity.
Pneumatic Cylinder Flow Control
Learners use animated needle valves and check valves to change the speed of a pneumatic cylinder as it extends and retracts. A brief quiz completes the learning object.
Hydraulic Directional Control Valves
In this animated activity, learners examine the operation of hydraulic directional control valves and the internal components that divert the fluid.
Shear - Hydraulic - Adira - Operator's Panel
By Dave Hoffman
Picture of Adira hydraulic shear's operator's panel with part identification and instructions on how to start and stop the shear as well as setting stroke (cutting length).
Calculating Bend Allowance for Press Brake Forming
Introduces two methods of determining bend allowance; one is simple and is an approximate, the other is more precise. Interactive part has learner calculate bend allowance and blank size.
Shear - Hydraulic - Adira - Setting Back Gauge
Step-by-step of setting the back gauge with an Adira Hydraulic Shear.
Determining Punch & Dies for Press Brake Forming
Introduction to selecting the proper punch and die for air bending or bottoming when forming on a press brake. Includes charts and methods for selection.
Creative Commons Attribution-NonCommercial 4.0 International License.
Learn more about the license »
Give your new group a name.