In this learning activity you'll practice reading a micrometer.
Ammco Brake Lathe Controls
By Bill Heesaker
In this animated activity, learners examine the various controls that operate an Ammco brake lathe.
Press Brake - Hydraulic
By Dave Hoffman
Identifies the parts of the hydraulic press brake featuring the Adira up-acting press brake. Interactive section asks to identify parts after first learning them.
Layout Project: Tool Bit Grinding Gage
By Kelly Curran
This project gives the student a drawing and steps to complete an activity.
Calculating Feed Speeds for Twist Drills
Students read how to calculate feed rates for drills in inches per minute (IPM). The IPM formula is given and students work two practice problems.
Measuring Length in the Metric System
By Nabila Dahche
In this learning activity you'll explore how units in the metric system are related to each other and practice locating measurements on a metric line.
Brakes: Measuring Brake Drums
By Ken Kempfer, Dan Claus, John Hadjikyriacos, Kevin Guthrie
Learners examine the proper way to set up standard and metric micrometers to measure the wear on a brake drum.
Proper Digital Multimeter Placement
By David Schwid, Patrick Hoppe
In this interactive and animated activity, students follow the steps for proper digital multimeter placement for resistance, voltage, and current.
Calculating Board Feet
By Patrick Molzahn
Learners review the process for calculating board feet and use virtual samples to practice the process.
Using a Lumber Rule
Learners read how to use a lumber rule to quickly and accurately estimate board feet. They then use virtual samples to practice the process.
Creative Commons Attribution-NonCommercial 4.0 International License.
Learn more about the license »
Give your new group a name.